![]() ![]() The character limit is 1024 characters and 4096 characters after expansion. Construct the watermark using any combination and order of the information variables. String constructed using any of the available information variables:ĭefines the text that you want to display for the digital watermark. As the watermark scales, the margin also scales proportionally.Īn integer within the range of values: 0–255ĭefines the transparency level of the digital watermark text. If the watermark size exceeds the square size, it is scaled to maintain the aspect ratio.Īn integer within the range of values: 0–1024ĭefines the amount of space (in pixels) around the digital watermark for the Tile layout. 2 = Multiple: Watermark appears in the center and four corner squares.1 = Center: Watermark appears in the center square.Application sessions always use this layout. 0 = Tile: Watermark appears in all nine squares.For information about the feature, see Features of Linux Desktops in Horizon 8.ĭefines the font used for the digital watermark.Īn integer within the range of values: 8–72ĭefines the font size (in points) of the digital watermark.ĭefines the layout of the digital watermark on the screen, which is divided into nine squares: Environment variableĬorresponding option in /etc/vmware/configĮnables or deactivates the digital watermark feature. The environment variable settings take priority over the settings in /etc/vmware/config. Each environment variable maps to a corresponding configuration option in the /etc/vmware/config file. In Dynamic Environment Manager, configure the environment variables described in the following table. Note: After saving your new or updated environment variables in a high-latency network, wait at least a minute whileĭynamic Environment Manager finishes processing the changes before you make the affected desktops available to your end users.ĭynamic Environment Manager Environment Variable Values for the Digital Watermark Feature Repeat this procedure for each additional environment variable that you want to configure for digital watermark. To save the environment variable, click Save.The AND operator is added by default to combine the conditions. To add more conditions after configuring the first condition, click Add again.Select the Conditions tab, click Add, and select the condition that you want to configure.įor detailed information about configuring supported conditions and condition values, see Adding Conditions to Horizon Smart Policy Definitions and Environment Variable Definitions.Add the conditions required to use the environment variable with remote Linux desktops.In the Environment Variable Settings section, enter the variable name and value exactly as described in the " Dynamic Environment Manager Environment Variable Values for the Digital Watermark Feature" section that follows this procedure.In the General Settings section, enter a name for the settings definition in the Name text box.Click the Settings tab and define the environment variable settings.To create a new environment variable, click Create.In the Dynamic Environment Manager Management Console, click the User Environment tab and then select Environment Variables.Įxisting environment variable definitions, if any, appear in the Environment Variables pane.Use the following steps to configure environment variables that define the settings for a digital watermark on a Linux desktop. See Setting Options in Configuration Files on a Linux Desktop.Ĭonfigure Environment Variables in Dynamic Environment Manager Enable the DEMEnable option and configure the DEMNetworkPath option in the /etc/vmware/nf file.See Installing Dynamic Environment Manager and Configuring Dynamic Environment Manager. Install and configure Dynamic Environment Manager.You can configure environment variables in Dynamic Environment Manager to control the behavior of the digital watermark feature on specific Linux desktops.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |